The industry's leading cross-reference database.

Shopping for air compressor parts, made easy!

Call us today 800-866-2959

FILTER ELEMENT CLEANING INSTRUCTIONS

CLEAN BY HAND WASHING

  • Soak and agitate element in a warm water & mild detergent solution.
  • Allow adequate time for the element to air dry. (24 hours minimum)
  • Do not install a damp element. This will cause higher initial pressure loss & rapid dirt loading.
  • The dry element is ready to be re-used.

CLEAN BY COMPRESSED AIR

  • Using approximately 100 PSI, direct air flow at inside of element towards pleats.
  • Blow off the outside of the element directing the air flow down to avoid embedding dirt in the media.
  • Blow off the inside again to remove any dirt that might be on the clean side of the element.
  • The element is ready to be re-used.

CLEANING BY VACUUM

  • Remove element from housing.
  • Vacuum from dirty side only, using a vacuum of approximately 40" w.c.
  • A crevice attachment is recommended.
  • The element is ready to be re-used.

CLEANING BY HAND

  • Remove element from housing.
  • Hold element down with one hand & move other hand across the fins in a strumming motion. This action will dislodge most of the dirt.
  • The element is ready to be re-used.

The Best Reason to use a Synthetic Felt Media is Re-Usability.

Typically, customers can expect these filters to be re-washed 6-8 times, some have even reused these 10 times.

Take a look at the Differences between Paper and Synthetic Media Air Filters.

Please submit your contact details and we will be in touch very shortly regarding your enquiry

Are you a reseller?
× Continue looking for Parts